As part of the Pentium family of computer processors, the Pentium 4 processor was designed on a new architectural format from former models. This new system, called Netburst, allowed for longer pipelines, creating higher frequencies and better performance. When replacing your Pentium 4 processor, verify that the motherboard and system will support the processor. A Pentium 4 processor requires a 4-pin 12V ATX12V cable connected to the motherboard from the power supply. Replacing the processor is physically a simple process, and by following a few details you can have your new Pentium 4 processor installed quickly and ready to go.
Instructions
Replace Pentium 4 Processors
1. Examine the new Pentium 4 processor and verify that all the pins are straight and ready to be plugged into the motherboard. If any of the pins are bent, carefully push the pins back into place by hand.
2. Shut the computer off and unplug the electrical cord on the back of the computer base from the power source. Then undo the screws on the back of the central processor unit (CPU) with a screwdriver and slide the case top off of the base. Lay the case down so that the motherboard is lying flat, even with the table surface that you are using.
3. Locate the Pentium processor that is in the motherboard. Remove the old processor by lifting the socket handle on the side of the processor until it is vertical to the motherboard and lifting the processor straight up until it is clear of the pin sockets and then take the processor out of the CPU. Do not lean on any parts connected to the motherboard while lifting the processor out.
4. Turn the new Pentium 4 processor over so that you are looking at the pin side and locate the triangle in the corner of the processor. You will use this corner as your orientation point. Line up the corner with the marking on the processor sockets on your motherboard. When you have the new processor in position, push down slowly and carefully to prevent any pins from getting bent or damaged.
5. Press the center of the processor and each of the corners to verify that it is seated properly in the motherboard. Close the lever on the side of the processor to lock it into the motherboard.
6. Slide the cover back over the computer base and secure the cover with screws. Plug the electrical cord from the computer back into the power source and turn the computer on to verify the processor is working properly. When you are satisfied, turn the computer off.
Tags: Pentium processor, that motherboard, verify that, your Pentium processor, back into, computer base